• Welcome

There is no danger if there is any damage to the chassis parts of the car

Blog 2年前 (2022-02-24) 254 Views

Car owner's car knowledge]When the car breaks down while away from the repair shop, that's a real headache. There is no danger if you are prepared. After you have a car, you should pay attention to the maintenance of the car.

There is no danger if there is any damage to the chassis parts of the car

First aid for damaged car chassis parts

When the car is in the wild or far away from the repair site and the chassis parts are damaged, the following first aid methods can be used to drive the car to the place where the car is repaired according to different fault conditions.

If the brake cylinder leaks brake fluid or the cylinder pipe is broken, you can make a small cushion with iron sheet or copper sheet at the pipe joint of the cylinder cylinder, block the pipe, then tighten the screw, or flatten the fracture, Curl plugging, so that the wheel can not be used as a brake. But doing so may cause unilateral braking, so pay attention to safety while driving.

There is no danger if there is any damage to the chassis parts of the car

The brake master cylinder lacks brake fluid, which can be replaced by alcohol or liquor, and in special cases, water can be used instead. When the brake leather cup swells, soak the swollen leather cup in hot water for 10-20 minutes to remove the oily components on the leather cup, so that the leather cup can be restored to its original size.

The clutch friction plate is ablated and slipped, and the friction plate with less serious ablation can be turned over for use. If the ablation is serious, several layers of cotton cloth or canvas can be used (the thickness should be consistent with the original friction plate), and the steel wire or iron wire can be used to pass through the holes on the steel plate to make it fixed. When driving the vehicle, start smoothly and shift quickly.

There is no danger if there is any damage to the chassis parts of the car

If the ball joint of the tie rod is broken, in the bumper or other places that do not affect the driving, remove a screw with a similar overall length of the ball joint to replace the broken ball joint, install the steering knuckle arm and the nut, and expose the screw Parts are riveted with a hammer. If the gears of the three-axle automobile differential gear are damaged, if any one of the middle and rear axle differentials is damaged, the axle drive shaft and half shaft can be removed to continue driving. If the front differential is damaged, you can remove the hub engagement disc and continue driving.

Related recommended reading:
Scientific car maintenance saves money and summarizes 12 common mistakes in maintenance methods
http://news.16888.com/a/2013/1019/284958.html