How to remove the throttle valve of Jeep Compass, how to match the throttle valve of Compass

Guide toThe throttle valve disassembly method is as follows: 1. Disassemble the intake pipe and the air filter box connector, using pliers. 2. Disassemble the crankshaft ventilation pipe, T20. 3. Disassemble the air filter box, break it up manually, and then you can clean the upper part of the throttle. If you want to clean it completely, please remove the four screws and take off the throttle valve.

Installation: 1. The four screws that fix the throttle valve can be screwed by hand first, because the hands are more sensitive, avoid screwing the screws directly with a sleeve, and then tighten them with tools after screwing by hand. Then insert the plug, the installation of the plug requires a little force, and it means it is fixed after hearing a "click". 2. After the throttle valve is installed, the hose can be installed. There will be two small grooves on both sides of the hose, one large and one small, and they can be aligned with the raised marks on both sides. The hose should be completely inserted into both ends. If the installation is difficult, it can be installed while twisting left and right. 3. After the concave and convex points at both ends are completely aligned, touch the bottom of the hose with your hand to ensure that the bottom is also fully inserted, then tighten the screws on the iron hoop, install the engine decorative cover, and the cleaning work is completely over.

The matching method of the Compass throttle is as follows:

Throttle valve matching needs to use a special diagnostic instrument to read data, then follow the step prompts to perform adaptive zeroing, and finally start the vehicle, if it works normally, it means matchingsuccess. Throttle valve matching is an important step after throttle valve cleaning. If it is not matched, the vehicle is prone to abnormal idle speed in later use.