How to change the rubber strip for the bone wiper?Schematic diagram of removal of bone wiper

BoneWiperThe rubber strip can be replaced directly for daily maintenance, which can save money. Although it is easy to change the rubber strips, it is not always possible to change the rubber strips, because the steel strips in the wiper will also be deformed over time. The following is how to remove the rubber strip of the bone wiper:

1. The wiper is close to the front windshield. Raise the wiper arm first. Since the boned wiper is generally a U-shaped bayonet, the wiper can be removed by pressing and releasing the lock pin.

2. Next, disassemble the old rubber strip with the bone wiper. Pay attention to the two ends of the wiper. One end has a fixed groove, and the rubber strip is pushed out from the groove end.

3. After pushing out the rubber strip, remove the two steel strips inside the wiper blade.

4. Assemble the two steel bars and the new rubber strip, and then push the rubber strip back along the groove from the other end without the fixed groove.

5. After the fixing groove is stuck in, the wiper strip is replaced, and finally the U-shaped bayonet is installed with the recovery wiper.

Can a bone wiper be replaced with a boneless wiper?

If the original car has a bone wiper, then the boneless wiper can be replaced under normal circumstances. However, there is no need for us to specifically pursue boneless wipers, because there is no absolute advantage over boneless and boneless wipers.

Friends who need to replace, be sure to check whether the wiper is operating normally after replacement. If the wiper is dirty or abnormal, clean it or replace it directly.