Can I charge the battery without disassembling? Steps to charge the car battery without disassembling

Nowadays, there are more and more electric equipment on cars. If the car is in a state of deep discharge for a long time, it is very likely that the battery will lose electricity, and it may even cause the engine to be unable to start. So, at this time we need to charge the battery. However, many friends find it troublesome to remove the battery for charging, and they also ask whether the battery can be charged without removing it. In order to solve this problem for everyone, today we will talk about the steps of charging the car battery without removing it.

First connect the positive pole of the battery to the positive pole of the battery, and then connect the negative pole of the battery to the negative pole of the battery to charge. But don’t overcharge often,Although the current generated by the battery is not very large, because the electrolyte is in a boiling state for a long time,Not only the fine particles on the surface of the active material are easy to fall off, but in serious cases, the grid frame will be oxidized, causing loose peeling of the active material and the grid frame., So everyone must be full of energy when charging.Of course, in addition to the battery charging method, we can also jump start the generator for charging.

Jump start generatorA step of:

1. First make sure that the auxiliary battery is 12 V and the negative terminal is grounded. Of course, we have to turn off all unnecessary lights and accessories to avoid electricity accidents.

2. Then follow the order shown in the figure below to connect the jumper cables. Do not reverse the positive and negative poles of the cable, otherwise it will jump out of sparks when it is connected, and we must wrap the cable and the battery tightly (full contact) to avoid flashovers during the power connection. Phenomenon.

3. Start the engine of the auxiliary battery vehicle and run the engine at a medium speed.Then start the engine of the vehicle whose battery is exhausted. At this timeThe engine will drive the generator through the belt, and the generated electricity will be rectified and stabilized to directly charge the car battery.

4. Finally, just disconnect the cables in the reverse order.