Emergency car repair tips essential knowledge for vehicle maintenance

1.tankDamaged When the motor vehicle is in use, it is found that the fuel tank is leaking. You can wipe the leaking place clean, and apply soap or bubble gum to the leaking place to temporarily block it; use epoxy resin adhesive to repair it, and the effect will be better.

2. When the oil pipe is broken, wipe the broken part clean, apply soap, wrap the broken part of the oil pipe with a cloth or tape, and tie it tightly with iron wire, and then apply a layer of soap.

3. The tubing is broken. When the tubing is broken, you can find a rubber or plastic tube suitable for the diameter of the tubing to sleeve it. If the sleeve connection is not tight enough, tie both ends with iron wires to prevent oil leakage.

4. The motor vehicle cylinder head and other parts have blisters and oil and water leaks. According to the size of the blisters, choose the corresponding specifications for electricians.fuse, And gently smash it into the trachoma with a hammer to prevent oil and water leakage.

5. Oil pipe joint leakage. When a motor vehicle is used, such as engine oil pipe joint leakage, it is mostly caused by the leak of the oil pipe bell mouth and the oil pipe nut. You can use cotton yarn to wrap around the lower edge of the horn, and then tighten the tubing nut and tubing joint; you can also chew bubble gum or maltose into a paste, apply it to the tubing nut seat, and seal it after it dries. The artificial leather or leather belt can also be cut into a shape or placed in a hole to smash into a shape, and then installed, or a piece of plastic tube can be cut into shape and installed.

6. When the sedimentation cup is broken, use a tape or plastic tube to cover the inlet and outlet tubing of the sedimentation cup so that the oil does not pass through the sedimentation cup.

7. When the rupture of the inlet and outlet hoses is not large, you can use a cloth coated with soap to wrap the leaking area; if the rupture is large, you can cut off the rupture of the hose and put a bamboo or iron pipe in the middle , And tie it tightly with iron wire.

8.fanbeltFor breakage, tie the broken belt with iron wire in series or drive the car away by starting and stopping.

9. Screw hole sliding buckle Screw hole sliding buckle causes oil leakage or loose connecting rod, making it unable to work. At this time, the original screw can be flattened with a hammer to increase the expansion on both sides, and then tighten it, but it can not be disassembled many times, and it will be repaired during the next maintenance. (Dahe Net)