[Auto maintenance knowledge]DIY wireless reversing image installation steps

The wireless reversing visual system has the characteristics of simple installation, convenient wiring, economical and practical, and is currently widely used.

The steps to install the wireless reversing visual system are as follows:
1. Remove the license plate
2. Remove the inner layer of the tail box
3. Open the license plate lamp cover
4. PutCameraPass the power cord into the car through the license plate light hole, and fix the line
5. Fix the camera on the license plate frame
6. Connect the camera power cord to the power supply of the reversing light according to the positive and negative relationship
7. Restore the disassembled parts at the rear of the car
8. Insert the power supply of the display into the cigarette lighter and place the display
8. Startcar, Put the reverse gear to display the reverse image

special reminder:
1. When the camera power cord is passed through the tail cover, it will be smoother to use a small wire to pull it.
2. After installation, please pay attention to check whether the night light of the camera is turned on when reversing. If it is not turned on, it means that the power is not connected.
3. The launcher must be placed where it can lead to the front of the car. It cannot be placed in the steel interlayer of the back cover of the car. This may affect the camera and display screen after installation, no signal or poor image due to the steel plate.

51 Auto Service Center

Visual reversing imaging expert

　　　　　　　　　　　　　　　　　　Wireless reversing image/wireless visual reversing

Related:

·Reasonable selection of patterns related to drainage capacitytire[汽车修理常识]
·Instructions for long-distance travel: maintenance tools to be carried with the car[汽车修理知识]
·Safety first airbagcommon sense[汽车修理常识]
·Catalytic exhaust purifier[汽车维修知识]
·Look at EBD from the new car[汽车维修知识]
·From ASR to ESP[汽车修理知识]
·Talking about other things from the "ground clearance"[汽车修理知识]