Five basic skills of car knowledge, turn in, slow in, fast out in oil

Turning is skillful, and the masters on the track usually have 5 necessary basic turning skills. Those who plan to go to the track may wish to learn about the basic skills of these corners.

Turning route:

Outside-inside-outside

If you want to go through the curve quickly and do not want to generate too much centrifugal force when turning, you must make full use of the width of the road and try to turn in a large arc that tends to a straight line. Therefore, lean against the curve before the start of the turn. When entering the curve from the outside, when in the middle, you must drive on the inside of the curve. That is to say, you should drive close to the inside of the curve at the top of the curve. After passing the top of the curve, cut again Back to the outside of the curve, lean on the outside of the curve to exit the curve, that is, choose the "outside-inside-outside" turning route when you pass the curve.

Turning principle:

Slow in, medium oil, quick out

You should step on when you are still driving in a straight line before entering the curvebrakeLet the car slow down. If the curve is relatively large, the speed should be further reduced, and at the same time, the speed should be lowered first; after entering the curve at a low speed, first select the turning route and correct direction, and then step on the accelerator, the car can simply turn; When you see the end of the curve, movesteering wheelBack to the right, after confirming that the road conditions are safe, just refuel and exit the corner quickly.

How to pass an uphill curve

When passing an uphill curve, you should release the throttle before entering the curve, let the vehicle enter the curve at a faster speed and lean on the outside of the curve, then lower the gear by one or two gears, then choose the route and correct the direction , And tap the throttle at the same time; after passing the top of the curve, cut back to the outside of the curve, increase the throttle at the same time, and finally lean on the outside of the curve to quickly exit the curve.

How to pass downhill curves

When passing a downhill curve, you should release the accelerator and apply the brakes before entering the curve, so that the vehicle will slow down greatly, and the gear should be lowered by one or two gears, and then enter at a slower speed against the outside of the curve After turning off the brake, choose the route and correct the direction; after passing the top of the curve, cut back to the outside of the curve, tap the accelerator, and finally lean on the outside of the curve to quickly exit the curve.

How to pass blind corners

Blind corners are corners where the exit cannot be seen. When driving on a curve in a blind spot, because you cannot see the traffic at the end of the curve, you must first reduce the speed of the car, and you cannot drive in a normal curve. In order to avoid accidents with oncoming vehicles, you must drive on the side of the road. When passing a left curve,carYou should drive along the outside of the curve. When passing a right curve, the car should drive along the inside of the curve. Once you see the exit of the curve, you can change lanes and correct the direction. Method, fuel the throttle to accelerate out of the curve.

There is a lot of gap between turns on the track and turns in real life. At least the track is one-way, and there will be no cars on the opposite side. With this alone, track skills cannot be abused. Strive for speed on the track, and safety in life is the first demand for driving. (Haoche.com)