How to clean the Mazda 6 Atez throttle valve, Atez throttle valve cleaning method

Mazda6AtezThere are two ways to clean the throttle:

1. Remove it and use carburetor cleaner (referred to as carburetor) to clean the throttle body (or leave it on the car without disassembling it, spray it with carburetor and then wipe it);

2. Use maintenance-free maintenance cleaning of the engine's intake duct (start the car, then use a cleaning agent or cylinder with its own pressure to spray the throttle valve, and continuously increase or decrease the accelerator so that the engine does not stall). Manual disassembly and cleaning can only clean the throttle valve, while non-disassembly and cleaning can also clean the carbon deposits on the top of the piston in the intake duct and valve door, and the cleaning range is very wide. No matter which method is used, after cleaning the throttle valve, you must use the computer to initialize and reset the throttle valve, otherwise the problem of idle jitter will occur.

The throttle is a controllable valve that controls the air entering the engine. After the gas enters the intake pipe, it will mix with gasoline to form a combustible mixture, thereby burning and doing work. It is connected to the air filter on the top and the engine block on the bottom. It is called the throat of the car engine.