How to clean the Cadillac xt5 throttle valve, Cadillac xt5 throttle valve cleaning method

CadillacHow to disassemble and clean the xt5 throttle valve:First with10mmUse the socket to remove the engine guard, and thenFirst with10mmUse the socket to remove the engine guard.Remove the air intake plastic pipe. Use a screwdriver to pry up the middle of the plastic clip and pull it out gently to remove the air inlet.Then remove the pipe on the air intake hose.use

CadillacHow to disassemble and clean the xt5 throttle valve:First with10mmUse the socket to remove the engine guard, and thenFirst with10mmUse the socket to remove the engine guard.Remove the air intake plastic pipe. Use a screwdriver to pry up the middle of the plastic clip and pull it out gently to remove the air inlet.Then remove the pipe on the air intake hose.use8mmUse the sleeve to loosen the screw near the throttle clamp.

Then loosen the screw at the other end.Remove the intake soft hose between the air filter and the throttle. The hose can be removed with a little force.Remove the hose from the carbon filling solenoid valve, use pliers to hold the clip, and then pull it out. This method is used to remove the hose.Also remove the other two pipes of the throttle. Note that a little water will drip out of the water hose.Remove the throttle valve.

The key tool appears (ratchet wrench), which is also used8mmThe sleeve is much more convenient, otherwise it would take a lot of work.The throttle valve was completely removed, but it was still quite dirty. Be careful not to unplug the connection plug from the throttle at this time, and keep the connection firmly in contact with the throttle during the entire cleaning process.The throttle valve was completely removed, but it was still quite dirty.

Be careful not to unplug the connection plug from the throttle at this time, and keep the connection firmly in contact with the throttle during the entire cleaning process.This is what is used3MThrottle valve (door) cleaner. It is best not to use carburetor cleaner.Adjust the movable trigger, change the direction of the ratchet wrench, install the throttle valve, and connect the various pipes.Be careful not to connect the pipes above and below the throttle incorrectlyThis is after cleaning and installation, and the pipes have been connected.