How to disassemble the BYD S7 throttle valve, and how to clean the BYD S7 throttle valve

BYDThrottle valve cleaning method:

1. No disassembly and cleaning

Disassembly-free cleaning is relatively simple, and there is no need to replace some seals, gaskets and other parts. Nowadays, in most cases, disassembly-free cleaning is adopted.

2. Remove all the throttle body and clean it.

If the oil clog is particularly serious, it needs to be removed and cleaned. If the situation is serious, the cylinder head may even need to be opened for cleaning. Therefore, it is recommended that all car owners have their throttle valve cleaned at a professional maintenance shop.

Antifreeze production equipment air conditioner cleaning tutorial how to see coolant tracking and positioning in rearview mirror headlight modification

How to clean the throttle valve yourself?

Tools required: carburetor cleaner, gloves, tool box

1. Remove the throttle valve

Remove the engine cover to facilitate removal of the pressure pipe and the lines fixed to it. Car owners need to pay attention to preventing the screws from falling into the engine compartment during the removal and installation of screws.

After removing the pressure pipe, we can seeGorehusband6 throttle. Since the throttle valve is located relatively low and there are many pipelines around it, car owners must be careful when removing the throttle valve to avoid damaging the pipelines.

After taking out the throttle, the engine block is exposed. The car owner must guard this gap and remember to cover the breather pipe to prevent foreign matter from entering the engine block.

2. Clean the throttle valve

After taking out the throttle, we canDiscoverThere are a lot of oil stains inside and outside the throttle valve, and a lot of dirt and impurities are also stuck on it.

After spraying the cleaner on the dirty area, you can wipe it carefully with a cloth. Don't be lazy when wiping, pay special attention to the gaps where dirt and evil tend to hide. If the gap is too small, you can use a cotton swab dipped in some detergent to clean it.

As long as we wipe it carefully, the throttle can be clean and as good as new. With a clean throttle, your car can "breathe" smoothly and freely.

3. Install the throttle valve

The four screws that fix the throttle can be tightened by hand first. Because your hands are relatively sensitive, avoid twisting the screws directly with a sleeve. After tightening by hand, you can use tools to tighten them. Then plug in the plug. It requires a little force to install the plug. You will hear a "click" sound to indicate that it is fixed.

After the valve is installed, you can install the hose. There will be two small grooves on both sides of the hose, one large and one small. Just align them with the large and small raised marks on both sides. The hose should be completely inserted into both ends. If it is difficult to install, you can install it while twisting it left and right. After the concave and convex points at both ends are completely aligned, touch the bottom of the hose with your hand to ensure that the lower part is completely inserted, tighten the screws on the iron hoop, install the engine decorative cover, and the cleaning work is completely over.