How much does it cost to clean the throttle valve of Huansu S3? How long does it take to clean the throttle valve of Huansu S3?

Cleaning the throttle of Magic Speed ​​S3 costs about 200 yuan. The throttle is a controllable valve that controls the air entering the engine. After the gas enters the intake pipe, it mixes with gasoline to become a combustible mixture, which is burned to produce work. It is connected to the air filter on the top and the engine block on the bottom. It is called the throat of the car engine. How often to clean the throttle depends on the vehicle owner's usage environment. If the vehicle is in a place with serious environmental pollution, it needs to be cleaned regularly.

Things you need to pay attention to when cleaning the throttle valve of Magic Speed ​​S3:

If there is too much sludge on the throttle, it may cause poor engine acceleration and increase fuel consumption, which is a big worry for car owners. So what should you do if the throttle is dirty? Just clean it. You can get it done quickly by going to the 4S store, but don’t you have to go to the 4S store every time for cleaning? Actually, no, you can do it yourself, just don’t forget to initialize it.

First, put a little oil on the fixed metal ring to prevent the teeth from slipping during disassembly. Remove the metal bundle ring of the throttle hose. After removing the hose, the left end is where the throttle valve is. Remove the negative electrode of the battery, turn off the ignition switch, straighten the throttle flap, and spray a small amount of "carburet" into the throttle valve. Then use a polyester rag or high-woven "non-woven fabric" to carefully scrub. Deep inside the throttle and out of reach, you can use a clip to hold the rag and scrub carefully.

It is not necessary to disassemble the throttle when cleaning, but the sealing part of the steam inlet must be cleaned. The idle motor must be disassembled before it can be cleaned. There are advantages and disadvantages to disassembling the injector for cleaning or eliminating the need for disassembly. Under normal circumstances, the maintenance station recommends that it does not require disassembly. Disassemble and wash to prevent other unnecessary waste, such as the need to replace the sealing ring or the installation of other gaskets after disassembly, or oil leakage, gas leakage, etc. during the disassembly and assembly process, which delays the car owner's time.