How to disassemble the Changan Eado throttle and how to match the Eado throttle

Chang'anEscapeThe disassembly and assembly methods of the throttle valve are as follows:

Disassembly: 1. Remove the connection between the intake pipe and the air filter box, use powerful pliers, 2. Remove the crankshaft ventilation pipe, T20, 3. Remove the air filter box, pull it up manually, and then you can clean the upper part of the throttle. . If you want to clean it completely, please remove the four screws and take off the throttle.

Installation: 1. The four screws that fix the throttle can be tightened by hand first. Because your hands are relatively sensitive, avoid twisting the screws directly with a sleeve. After tightening by hand, you can use tools to tighten them. Then plug in the plug. It requires a little force to install the plug. You will hear a "click" sound to indicate that it is fixed. 2. After the throttle is installed, you can install the hose. There will be two small grooves on both sides of the hose, one large and one small. Just align them with the raised marks on both sides. The hose should be completely inserted into both ends. If it is difficult to install, you can install it while twisting it left and right. 3. After the concave and convex points at both ends are completely aligned, touch the bottom of the hose with your hand to ensure that the bottom is completely inserted, tighten the screws on the iron hoop, install the engine decorative cover, and the cleaning work is completely over.

Matching method of Changan Eado throttle: Disconnect the negative battery cable when the car is hot, for no less than three minutes. After three minutes, install, reset and tighten the battery stake.Then return to the car and pressone-button startPress the button twice to light up the instrument panel (remember not to step on the clutch or brake, and do not start the engine directly). After the vehicle self-inspection is completed, press the accelerator pedal to the bottom for more than 5 seconds, and then release it. Release the accelerator pedal, wait until it is completely reset, start the vehicle, and keep the speed above 3000 for no less than 10 seconds (just step on the accelerator pedal slowly, watch the speed rise slowly from 1500 2000 2500 3000, don't You can't control it if you put your foot down). After more than ten seconds, release the accelerator and turn off the engine after the speed drops. Restart the vehicle and this throttle matching is completed.