【Car owner’s home car knowledge】Although there is no aging problem on the paint surface of a new car, it should be thoroughly protected before use. From the time it leaves the factory to being transported to the parking lot, the car's surface paint has been exposed to air, acid gas, and wind and sand. Prompt and correct maintenance can extend the use of your car. If you are buying an imported car, the first thing to consider is that car wax contains paraffin, resin, Teflon and other materials. When removing wax, do not use gasoline or kerosene to wipe it. Instead, use professional waxing liquid, or go to a professional beauty care shop and ask a technician for help. As for domestically produced cars, most of the car bodies are electrostatically sprayed, and the paint surface has a mirror gloss, so there is no need for waxing.
For the first cleaning, it is best to go to a dust-free manual car wash room and use a neutral and mild detergent to remove sand and dirt from the car paint surface. Some contaminants cannot be seen with the naked eye, such as paint, gum, alkali, acid and other chemical contamination, which cannot be removed by simply using detergent.
Protective measures before vehicles enter water
There has been a lot of rain recently, so be prepared in advance if you encounter standing water. Before a car travels through water, it is necessary to carefully check the depth, flow rate and bottom conditions of the water, as well as the width of the water entering and exiting the water and the road conditions, to determine whether it can pass safely. If the water depth exceeds the maximum wading depth of the wheel or car, it is not advisable to risk wading. In fact, as long as the water level reaches two-thirds of the front bumper or tire, it is dangerous to drive through water.
When confirming that the car you are driving can pass, you should generally choose the section with the shortest distance, shallowest water level, slow water flow and the solid bottom. If you want to drive through deep water, please make the following preparations first.
◆Wrap the distributor, high-voltage wires, ignition coils, etc. with tarpaulin or plastic bags, and try to raise the position of the battery (such as in the cockpit or on the car).
◆The filler port of the fuel tank, the oil dipstick hole and other vents on the engine and drive axle must be wrapped and blocked with waterproof materials.
◆If the water level is close to the maximum wading depth of the car, a wider wooden board should be tied to the front bumper, and then drive in low speed so that the water in front of the car is pushed away by the wooden board, forming a shallow water area at the engine area to prevent The ignition system was soaked in water and lost its functionality.
◆When possible, increase the weight of the car as much as possible to reduce the buoyancy effect of water on the car and increase the adhesion of the wheels.
Use less alcohol-based products for car interior cleaning
Some cars with a very shiny appearance will look miserable as soon as you open the door or engine compartment. If the vehicle has been driven for a long time, cleaning the interior and engine compartment is also very necessary.
The cleaning of vehicle interiors mainly focuses on cleaning seats, floors, ceilings and instrument panels. When using detergent to clean, choose different detergents according to the different textures of the vehicle interior. To clean pure leather instrument panels, do not use plastic cleaners, but use leather care agents; to clean plastic instrument panels, you can use instrument wax.
No matter what area you are cleaning, it is best to use a cleaner with a low alcohol content, as alcohol can cause damage to the interior. The method to judge the alcohol content of a detergent is very simple. If the foam content is high, or it evaporates quickly when applied on the back of the hand, it means that the detergent has a high alcohol content.
Carpet cleaning tips
The carpet is the easiest thing to get dirty in a car. If you use a vacuum cleaner with a brush head to clean it, you can make the dirty carpet look less dirty.
For dirtier carpets, special detergents can only be used. Generally, before using detergent, carry out the above two dust removal tasks, then spray an appropriate amount of detergent, scrub it clean with a brush, and finally wipe off the excess detergent with a clean rag. This can make the washed carpet both Clean and as soft as ever.
The most important thing to note is that the carpet should not be soaked and scrubbed completely in water. On the one hand, it will destroy the bonding of several layers of different materials inside the carpet. On the other hand, it will not dry out for a long time, affecting the use effect and causing car damage. Moisture inside.
Email: