The front windshield of a car is dry and frictional, how to solve the problem of new car wiper bounce

The car’s front windshield appears dry and frictional, mainly becauseWiperThere is a problem with the adhesive strip on it. It is possible that a lot of sand, dust and other impurities are attached to the adhesive strips, and this problem occurs. You can use sandpaper or toothpaste to polish the adhesive strips to effectively solve the problem. It is also possible that there is relatively strong bird droppings or stones on the front windshield, which causes the rubber strip to be damaged when cleaning the front windshield. The problem can be solved by replacing the new rubber strip.

How to solve the problem of new car wiper bounce:

1. First prepare a piece of water sandpaper, then remove the wiper from the vehicle, and put the wiper and water sandpaper in the bucket to soak. After the wiper is moistened with the water sandpaper, you can use the water sandpaper to polish the rubber strips on the wiper brush. After a few minutes, it will be fine. After drying the wiper, install it back to its original position;

2. Clean the front windshield;

3. Replace the rubber strip on the new wiper.

When car owners use the wiper to clean the front windshield, they should pay attention to the car’sGlass waterIs there any deficiency? If there are some bugs, dust, etc. on the front windshield of the vehicle that affect the vision of the owner, use a wiper to clean it. If the vehicle does not have glass water, the wiper may produce a lot of damage. Noise, and will also cause certain loss to the wiper brush.