The wiper stops in the middle and can’t be restored. What should I do if the wiper is halfway stuck?

WiperIf there is a situation where it cannot be restored when it stops in the middle, first check whether there is any foreign matter between the front windshield and the wiper. If there is, remove the foreign matter. Also check whether the wiper arm is rusty, it may cause rust to cause the wiper to be out of place, if so, remove the rust or replace the wiper arm. Check whether the circuit of the wiper motor is short-circuited. If so, you can go to a 4s shop or repair shop to deal with the motor circuit.

What to do if the wiper is stuck halfway down:

1. Corresponding to the wiperfuseIt burned, causing the wiper to get stuck in half.Need to open the inside of the front cabin coverFuse box, Check whether the fuse is burnt, if so, just replace it with a new one;

2. The wiper motor is burned out. You can open the wiper to check. If the motor is not burned out, there will be a sound. If there is no sound, it means that the wiper motor is broken. You need to go to a 4s shop or repair shop to replace the wiper motor.

If the ownerdiscoverThe front windshield is not cleaned by the wiper, so you don't need to go to the 4s shop or auto beauty shop for treatment, you can also deal with this problem yourself. To deal with the dirty wiper wiper, first prepare a piece of water sandpaper, then remove the wiper from the vehicle, and soak the wiper and water sandpaper in a bucket. After the wiper is moistened with the water sandpaper, you can use the water sandpaper to polish the rubber strips on the wiper brush. After a few minutes, it will be fine. After drying the wiper, install it back to its original position.