What to do if the wiper is not clean?Tips for not cleaning the middle of the boneless wiper

If the ownerdiscoverWiperIf the front windshield is not clean, you don't need to go to the 4s shop or auto beauty shop to deal with it, you can also deal with this problem yourself. To deal with the dirty wiper wiper, first prepare a piece of water sandpaper, then remove the wiper from the vehicle, and soak the wiper and water sandpaper in a bucket. After the wiper is moistened with the water sandpaper, you can use the water sandpaper to polish the rubber strips on the wiper brush. After a few minutes, it will be fine. After drying the wiper, install it back to its original position.

bonelessWiperTips for dirty scraping in the middle:

1. The spring pressure of the wiper arm is not enough, and the glass will not be scraped if it can't be pressed down, and it will be dirty. You can properly adjust the spring pressure of the wiper arm or replace the wiper arm spring;

2. The boneless windshield wipers were not adjusted properly when installed, resulting in a big error between the curvature of the windshield and the curvature of the front windshield. Reinstall and adjust the curvature to solve the problem;

3. The middle position of the rubber strip of the boneless wiper is severely worn by sand, dust and other impurities, just replace the rubber strip.

Many car owners also encounter the problem that the wiper does not spray water. The troubleshooting methods are as follows:

1,Glass waterIn case of shortage, add glass water in time, find the position of the wiper water tank in the engine compartment, just open the lid and add glass water inside;

2. If the glass water freezes, first add hot water with a suitable temperature or open it to a higher temperature place, and let it go after the frozen glass water melts, and replace the glass water with a higher freezing point;

3. If the scale is blocked in the water tank pipe or the wiper nozzle, just clean the blocked place;

4. If the leak is caused by the rupture of the water tank or the broken pipe, the leak must be found and replaced.