• Welcome

Analysis on the Seven Faults of Automobile Braking System

News 9年前 (2015-05-04) 137 Views

Brake is an important part of our driving process, the maintenance of the braking system is related to the safety of the whole car. We need to focus on the brake system of small problems, and timely solution, the security risks stifled in the cradle.

First, the brakes weak

It is likely that the pressure transmission line is depressurized, resulting in failure to provide brake force in time. At this time should be promptly to the regular brand shop or garage for maintenance.

Second, continuous brakes, pedal position increased, and a sense of sinking
There is no doubt that this is the oil spill.

Third, when the brakes trembling
Excessive wear in the car, the flatness of the surface of the brake disc to a certain extent has been inaccurate, if such a situation, it is recommended that you go to the regular brand shop or repair shop for maintenance, grinding the brake disc, or directly replace. General car age is relatively easy to happen this phenomenon.

Fourth, when the steering wheel "bias brake"

When the brake is about to stop, the steering wheel will be deflected to the side, the main reason is because the brake system left and right cylinder on the brake pads due to uneven force. However, in the normal driving process, because the brake disc rotation speed is very fast, the role of uneven pump in the fast friction is not obvious, so we are difficult to detect.

Fifth, when depressing the brake pedal, the pedal does not resist the rebound
At this time to determine whether the brake fluid is missing, brake cylinder and pipe joints are leaking, the main pump and pump parts are damaged and so on.

Sixth, the brakes harden

Many female drivers will encounter the problem of hardening brakes, brakes hardened mainly due to failure of the vacuum booster brake caused no help, frequent brakes caused by the resulting.

Seventh, the brake becomes soft

Brake softening is the abnormal braking force weakened, this failure usually for three reasons: the first is the pump or the master pump is not enough oil pressure may occur; the second is the brake failure, such as brake pads, brake Plate; the third is the brake pipe into the air, if the continuous foot when the pedal height slightly increased, and a sense of elasticity, indicating that the brake pipe into the air.

Above is the brake brake system common some failures, if your car appeared in these aspects of the fault, please immediately stop the inspection, to avoid a momentary mistakes caused by the accident.