The F3 has reverse lights. The reverse light switch of BYD F3 is on the gear lever. Car reversing light, installed at the rear of the car, is used to illuminate the road behind the car when reversing, and plays a role in warning the vehicles and pedestrians behind the car.
When the car is in reverse gear, the reversing light switch is connected to the reversing light circuit, and the white reversing light mounted on the back of the car lights up to warn the vehicles and pedestrians behind, and also plays the role of lighting. Some cars are also equipped with a reversing buzzer or a voice warning device, which sends an audible signal while reversing to indicate that the car is reversing. The replacement method of BYD f3 reversing light is as follows; 1. Open the trunk, and you can see a cover on the back of the tail light that can be opened. Open the left side first. Lift the cover and unscrew the two screws with a tool. 2. After the two screws are unscrewed, you can try to take off the whole taillight. The thread ends are disconnected, and they are all buckled, which is very convenient and does not break the thread. The taillights are removed, and a towel can be spread underneath to avoid scratching the lampshade. 3. The lamp holder and the lampshade are fixed with buckles, try to separate them slowly. It's where the red circle is. 4. The lamp holder is removed, and the red circle on the picture is the position of the reversing lamp. Unscrew it and replace it with a new LED bulb.
Email: