I don’t want to damage the floor structure, and I don’t want to install the lift by laying the foundation. Some people use steel plate as the low-level flat plate, and then weld the foot bolts of the lift to the steel plate, and use four wire ropes to connect the top of the lift to the top of the lift. The ground is fixed, forming a solid triangle. However, it is recommended that when installing a car lift, it is best to ask professionals to design and operate it.
Use of car lift
1. Park the vehicle on the lift station;
2. Adjust the position of the lifting arm, and align the block on the arm with the lifting point of the car;
3. Press the lift button and observe whether the car is in a horizontal state when the car is lifted;
4. When the vehicle is 5-10 cm away from the ground, pauseFor the lift, check again whether the vehicle is stable and whether there is any deviation between the fulcrums. If there is a problem, the vehicle should be put back on the ground and re-adjusted to ensure that the vehicle is placed on the lift steadily;
5. After confirming that there is no problem, continue to raise the vehicle to the required height, and then stop;
6. Pull down the locking device, check again whether the car is stable, if it is stable, start maintenance;
7. After the repair is completed, clean up the site, then pull the locking device, put the vehicle back on the ground, pull the lifting arm, and drive the vehicle out.
The above is the use process of the lift, every step needs to be operated carefully, to ensure that the vehicle is stable in the sky, and so on.
Email: