clutch oil withBrake Fluidit's the same. It uses the oil pressure of the principle that the liquid cannot be compressed, and pushes out the brake cylinder for braking. Compared with other liquids, clutch oil has the characteristics of evaporation, corrosion, oxidation resistance and fluidity. Common standards are DOT3 and DOT4. Toxic and easy to corrode the skin, which one to use, see the reminder on the oil cap.
Originally using the DOT3 standard, the DOT4 standard can be used. Conversely, the DOT4 standard was originally used, and the DOT3 standard cannot be used. During use, pay attention to sealing and should not be exposed to the air. When the remaining amount is relatively small, you can add it. It should be replaced when you notice that the color is no longer clear, preferably every 2 years.
Features shared by clutch oil and brake oil:
1. Anti-rust and anti-corrosion;
2. High boiling point, low freezing point;
3. Good resistance to rubber swelling;
4. Good viscosity and temperature.
In most cases, the purchase of brake fluid should be sufficient to meet the replacement needs of brake fluid and clutch fluid. There are also some models that use the same oil tank for brake oil and clutch oil. When replacing, you can achieve the goal of one replacement and two maintenance.
The replacement cycle of clutch oil and brake oil is also relatively similar. Normally, at 40,000 to 50,000 kilometers or about 3 years, you should pay attention to checking and replacing the oil. It is necessary to pay special attention to the oil. Once the water enters, the oil will deteriorate and the boiling point of the oil will decrease. It needs to be replaced in time to prevent the braking effect from malfunctioning.
Email: