• Welcome

What should I do if the trunk of Envision 1.5t cannot be locked?

Blog 11个月前 (05-29) 86 Views

When the trunk of Envision 1.5t (20t) cannot be locked, the owner should press the trunk and let other people release the release device of the trunk from the car at the same time, check the latch and the area where it is connected to the body; if the trunk Closed by an obstruction, any of them may be bent, deformed, or otherwise damaged; check the bodywork around the trunk for dents.

Usually the trunk cannot be locked or closed due to the following reasons, in order to automatically lift the rear hatch after pressing the open switch, a too stiff spring bar is used; the stopper rubber block and the lock are closed. The matching of the stop mechanism is not suitable; the trunk control circuit is faulty; the hydraulic support rod of the trunk is faulty. If the body is deformed, the latch may be out of alignment. In this case, it is best to contact a car repair center before attempting to remove the defect yourself. In fact, most of what you can do in the face of being unable to close the trunk is to try to increase the strength to close the trunk tightly, but don't blindly believe that "strength can work miracles" is indeed caused by the above reasons, and the strength will only intensify In case of injury, the first thing the car owner does is take the car to the repair shop for inspection.